What are the characteristics of ceramic fiber board

Ceramic fibreboard is a new type of decoration board, the type of board is not only the decorative effect is very good, but also quite environmental protection, so ceramic fibreboard has become a lot of friends like a kind of board, with everyone to understand, ceramic fibreboard features what? And how to install ceramic fibreboard and ceramic fibreboard manufacturers?

What are the characteristics of ceramic fibreboard

The main characteristics of ceramic fibreboard are correct size and high flatness, low thermal capacity and thermal conductivity, excellent compression strength and toughness, and excellent corrosion resistance, strong, easy to cut and install in peel resistance, long service life, excellent thermal stability of heat shock and sound absorption.

Ceramic fibreboard ceramic fibreboard is mainly used for lining material in heat treatment industrial kilns and expansion joints of the material, in the middle of the iron and steel industry package, insulating support, and under the insulation material of mold casting industry, lining hot surface material in petrochemical industry kilns, tunnel kilns heated to the zone material separated by high temperature and fire.

How to install ceramic fibreboard

1. First clean the walls and clean any debris or oil on the walls. If there is cracked concrete on the wall, scrape it off with a shovel. If the wall is empty, repair it again.

2. The flatness of bonded ceramic fiber board is very high, and the deviation should not exceed 4mm; If the deviation is large, the extrusion wall must be polished. Second, you need to find a concave wall, the hole should be at least 6mm thick, and the Angle of the wall should be square. The mortar used to make ceramic fiberboard also requires a special adhesive mortar and a special adhesive for the surface temperature.

3, slurry mixing ratio of water: mortar =10×: 5, mixing time should be more than 5 minutes, at the same time drainage. Stirring should be uniform and consistent enough. Mix with the mortar, let stand for 5 minutes and stir before applying. In addition, the mortar at this time needs to be mixed with mortar within one hour because the ceramic fiber can be more firmly combined to increase the binding force between the push plate and the mortar.